OPTEX FA D2RF - Цифровой оптический усилитель серии D2RF c двумя независимыми выходами

Digital Fiber Amplifier with Two Independent Outputs.
High speed 60 micro second response.

Standard Type : Stand-alone use
(IP50 protection)D2RF-TN/TP 2 meter cable
D2RF-TCN3/TCP3 M8 QD, 3 pin
D2RF-TCN4/TCP4 M8 QD, 4 pin

(IP66 protection)D2RF-2TN/2TP 2 meter cable
D2RF-2TCN3/2TCP3 M8 QD, 3 pin
D2RF-2TCN4/2TCP4 M8 QD, 4 pin

Standard Type : Interconnection use
(IP50 protection)D2RF-TMN/TMP Master Unit
D2RF-TSN/TSP Slave Unit
D2RF-TMCN4/TMCP4 Master Unit, M8 QD
D2RF-TSCN4/TSCP4 Slave Unit, M8 QD
Mark Sensor Type : Stand-alone use
(IP50 protection) D2GF-TN/TP 2 meter cable
D2GF-TCN3/TCP3 M8 QD, 3 pin
D2GF-TCN4/TCP4 M8 QD, 4 pin

(IP66 protection)D2GF-2TN/2TP 2 meter cable
D2GF-2TCN3/2TCP3 M8 QD, 3 pin
D2GF-2TCN4/2TCP4 M8 QD, 4 pin

Analogue Type : Stand-alone use
(IP50 protection)D2RF-TAN/TAP 4-20mA Analog / Transistor output

(IP66 protection)D2RF-2TAN/2TAP 4-20mA Analog / Transistor output

Features

APC Function (Auto Power Control)
The APC function ensures precise sensing even when there are changes in the temperature or environmental conditions.
APC maintains a constant power level of light emission by regulating the current flow into the light emission element. The APC function can be turned On and Off.

SAM Circuit - The ASC function
(Auto Sensitivity Control)
Our engineer "SAM" designed this function. The lens and/or reflector may be contaminated over time. The D2RF amplifier monitors the change in light level and automatically resets the threshold value.

After cleaning off the lens / reflector it used to be necessary to reset the threshold setting. The D2RF does not require this step. Simply clean off the lens and wait three seconds without a target present. The sensor will automatically reset the threshold level for the change. This is how the SAM circuit works.

After cleaning the incoming light level will increase suddenly. The SAM circuit computes the preset threshold based on the increase in light intensity.
This function is available only in Transparent Detection Mode.

Two four digit display's.
Received Light Level and Threshold Setting